Main Breaker Panel Installation – Source and Resource

On this video, you’ll discover how to put in a major breaker panel in your garage. If you’re unsure concerning electrical issues, call an experienced electrician.

Specifically, this video shows the Square D Homeline 100 amp breaker box. It’s important to make sure that it’s mounted securely. It’s mounted to the wall of the barn. The wires run through into the floor and up to the ceiling and finally out through the roof. Four conductors are used, but only three are employed in this instance. A coupling will connect the wires to the box. It is then time to connect the wires in your box. Before plugging in the wires, it is necessary to strip the wires of their ends. Use a screwdriver later to tighten them into place. Install the safety stickers to prevent accidental touching of the lugs. Install the duel pole with a 30-amp breaker. The breaker should just be able to snap into. In the same way, the 20 amps should also snap in. Finally, the wire must be pulled down from the top and plug into the breaker, creating a wire circuit.


Leave a Reply